eNSP單臂路由實驗(單臂路由配置實驗)
實驗拓撲圖
1、配置PC的IP地址：
PC1
PC2
PC3
2、配置交換機：創(chuàng)建VLAN 10 20 30 ，把與PC相連的接口劃入對應(yīng)的VLAN，更改接口模式， 把交換機GE0/0/1改為trunk，并允許通過VLAN 10 20 30。配置如下：
[Huawei]sysname S1
[S1]vlan batch 10 20 30 //創(chuàng)建VLAN 10 20 30
[S1]interface GigabitEthernet 0/0/2
[S1-GigabitEthernet0/0/2]port link-type access
[S1-GigabitEthernet0/0/2]port default vlan 10
[S1-GigabitEthernet0/0/2]interface GigabitEthernet 0/0/3
[S1-GigabitEthernet0/0/3]port link-type access
[S1-GigabitEthernet0/0/3]port default vlan 20
[S1-GigabitEthernet0/0/3]interface GigabitEthernet 0/0/4
[S1-GigabitEthernet0/0/4]port link-type access
[S1-GigabitEthernet0/0/4]port default vlan 30
[S1]interface GigabitEthernet 0/0/1
[S1-GigabitEthernet0/0/1]port link-type trunk
[S1-GigabitEthernet0/0/1]port trunk allow-pass vlan all
AR1配置：
[Huawei]sysname AR1
[AR1]interface GigabitEthernet 0/0/0.1
[AR1-GigabitEthernet0/0/0.1]ip address 192.168.1.254 24
[AR1-GigabitEthernet0/0/0.1]dot1q termination vid 10 //VLAN10打標簽
[AR1-GigabitEthernet0/0/0.1]arp broadcast enable
[AR1-GigabitEthernet0/0/0.1]interface GigabitEthernet 0/0/0.2
[AR1-GigabitEthernet0/0/0.2]ip address 192.168.2.254 24
[AR1-GigabitEthernet0/0/0.2]dot1q termination vid 20 //VLAN20打標簽
[AR1-GigabitEthernet0/0/0.2]arp broadcast enable
[AR1-GigabitEthernet0/0/0.2]interface GigabitEthernet 0/0/0.3
[AR1-GigabitEthernet0/0/0.3]ip address 192.168.3.254 24
[AR1-GigabitEthernet0/0/0.3]dot1q termination vid 30 //打VLAN30標簽
[AR1-GigabitEthernet0/0/0.3]arp broadcast enable
測試：
PC1
PC1
PC1
PC2
PC2
